CyberData 011214 Spécifications télécharger pdf (Page 51)

Installing the VoIP Outdoor Intercom with Keypad

Intercom Setup

Operations Guide 930809M CyberData Corporation

Backup SIP User ID 2 Specify the SIP User ID for the second backup SIP Server. This parameter

becomes the user portion of the SIP-URI for the device's extension on the

second backup SIP server. Enter up to 64 alphanumeric characters.

Backup SIP Auth ID 2 Specify the Authenticate ID for the second backup SIP server. This

parameter is required for SIP registration authentication. Enter up to 64

alphanumeric characters.

Backup SIP Auth Password 2 Specify the Authenticate Password for the second backup SIP server. This

parameter is required for SIP registration authentication. Enter up to 64

alphanumeric characters.

Remote SIP Port The Remote SIP Port is the port number the device will use as the

destination port when sending SIP messages. The default Remote SIP

Port is 5060. The supported range is 0-65536. Enter up to 5 digits.

Local SIP Port The Local SIP Port is the port number the device will use to receive SIP

messages. The default Local SIP Port is 5060. The supported range is 0-

65536. Enter up to 5 digits.

Outbound Proxy Enter the Outbound Proxy address as an IPv4 address in dotted decimal

notation or a fully qualified domain name (FQDN). When an IP address is

configured, the device will send all SIP messages to this IP address.

When an FQDN is configured, the device will run DNS NAPTR, SRV, and

A queries on the FQDN to resolve an IP address to which it will send all

SIP messages. This field can accept entries of up to 255 characters in

length.

Outbound Proxy Port The Outbound Proxy Port is port number used as the destination port

when sending SIP messages to the outbound proxy. A value of 0 will

default to 5060. The supported range is 0-65536. Enter up to 5 digits.

Disable rport Discovery Disabling rport Discovery will prevent the device from including the public

WAN IP address and port number in the contact information that is sent to

the remote SIP servers. This will generally only need to be enabled when

using an SBC or SIP ALG in conjunction with a remote SIP server.

Re-registration Interval (in seconds) The SIP Re-registration interval (in seconds) is the SIP Registration lease

time, also known as the expiry. The supported range is 30-3600 seconds.

Enter up to 4 digits.

Unregister on Boot When enabled, the device will send one registration with an expiry of 0 on

boot.

Keep Alive Period The minimum time in milliseconds between keep-alive packets sent for nat

traversal. A value of 0 will disable keep alive packets.

Nightringer Settings

Enable Nightringer When Nightringer is enabled, the device will attempt to register a second

extension with the SIP server. Any calls made to this extension will play a

ringtone (corresponds to Night Ring on the Audiofiles page). By design,

it is not possible to answer a call to the Nightringer extension.

SIP Server Enter the SIP server address as an IPv4 address in dotted decimal

notation or a fully qualified domain name. This parameter also becomes

the host portion of the SIP-URI for the device's Nightringer extension on

the SIP server. This field can accept entries of up to 255 characters in

length.

Table 2-16. SIP Configuration Parameters (continued)

Web Page Item Description

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 118 119

Commentaires sur ces manuels

Pas de commentaire

CyberData 011214 Spécifications Page 51

Commentaires sur ces manuels

Produits connexes et manuels pour Interphones de porte CyberData 011214