CyberData 011214 Spécifications télécharger pdf (Page 37)

Installing the VoIP Outdoor Intercom with Keypad

Intercom Setup

Operations Guide 930809M CyberData Corporation

Note You can change the SIP Volume, Multicast Volume, Ring Volume, Sensor Volume, and

Microphone Gain without rebooting the device. You must save and reboot the device for

other changes to take effect.

Misc Settings

Device Name Type the device name. Enter up to 25 characters.

Auto-Answer Incoming Calls

When selected, the device will automatically answer incoming calls.

When Auto-Answer Incoming Calls is disabled, the device will play a

ring tone (corresponds to Ring Tone on the Audiofiles page) out of

the speaker until someone presses the Call button to answer the call

or the caller disconnects before the call can be answered.

Button Lit When Idle

When selected, the Call button LED is illuminated while the device is

idle (a call is not in progress).

Button Brightness (0-255)

The desired Call button LED brightness level. Acceptable values are

0-255, where 0 is the dimmest and 255 is the brightest. Enter up to

three digits.

Play Ringback Tone

When selected, the device will play a ringback tone (corresponds to

Ringback Tone on the Audiofiles page) out of the speaker while

placing an outbound call. The Ringback Tone will play until the call is

answered.

Disable HTTPS (NOT recommended)

Disables the encrypted connection to the webpage. We do not

recommend disabling HTTPS for security reasons.

Click on the Test Audio button to do an audio test. When the Test

Audio button is pressed, you will hear a voice message for testing

the device audio quality and volume.

Click on the Test Microphone button to do a microphone test. When

the Test Microphone button is pressed, the following occurs:

1. The device will immediately start recording 3 seconds of audio.

2. The device will beep (indicating the end of recording).

3. The device will play back the recorded audio.

Click on the Test Relay button to do a relay test.

Click the Save button to save your configuration settings.

Note:

You need to reboot for changes to take effect.

Click on the Reboot button to reboot the system.

Click on the Toggle Help button to see a short description of some of

the web page items. First click on the Toggle Help button, and you

will see a question mark (

) appear next to some of the web page

items. Move the mouse pointer to hover over a question mark to see

short description of a specific web page item.

Table 2-7. Device Configuration Parameters (continued)

Web Page Item Description

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 118 119

Commentaires sur ces manuels

Pas de commentaire

CyberData 011214 Spécifications Page 37

Commentaires sur ces manuels

Produits connexes et manuels pour Interphones de porte CyberData 011214