Installing the VoIP V3 Intercom
Configure the SIP Parameters
Operations Guide 930472A CyberData Corporation
30
2.2.6.2 Point-to-Point Configuration
When the board is set to not register with a SIP server (see Figure 2-14), it's possible to set the
intercom to dial out to a single endpoint.
In this case, the dial-out extension should be the IP address of the remote device. The Intercom can
also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point
Mode.
Note Receiving point-to-point SiP calls may not work with all phones.
Figure 2-14. SIP Configuration Page Set to Point-to-Point Mode
Intercom is set to NOT register with a SiP server
Commentaires sur ces manuels