CyberData 011186 Spécifications télécharger pdf (Page 31)

Installing the VoIP V3 Intercom

Configure the Device

Operations Guide 930472A CyberData Corporation

3. After changing the parameters, click the Save button.

Enable Push to Talk This option is for noisy environments. When enabled, the

microphone will be muted normally. When the button is

pressed and held, it will unmute the microphone and allow

the operator to send audio back.

NOTE: When Enable Push to Talk is enabled, you cannot

stop an active call with the call button. The device on the

other end will need to end the call.

NOTE: Enable Push to Talk will not work on some older

hardware.

Click the Save button to save your configuration settings.

Note: You need to reboot for changes to take effect.

Click on the Test Audio button to do an audio test. When

the Test Audio button is pressed, you will hear a voice

message for testing the device audio quality and volume.

Click on the Test Microphone button to do a microphone

test. When the Test Microphone button is pressed, the

following occurs:

1. The device will immediately start recording 3 seconds of

audio.

2. The device will beep (indicating the end of recording).

3. The device will play back the recorded audio.

Click on the Test Relay button to do a relay test.

Click on the Reboot button to reboot the system.

Table 2-7. Device Configuration Parameters (continued)

Web Page Item Description

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 87 88

Pas de commentaire

CyberData 011186 Spécifications Page 31