CyberData 011272 Spécifications télécharger pdf (Page 43)

Operations Guide 930853D CyberData Corporation

Installing the VoIP Flush-Mount Indoor Intercom

Intercom Setup

2.4.8 Configure the Sensor Configuration Parameters

The door sensor (pins 5 and 6) on the header can be used to monitor a door's open or closed state.

There is an option on the Sensor Configuration page to trigger on an open or short condition on

these pins. The door sensor alarm will be activated when the Door Open Timeout parameter has

been met.

The intrusion sensor is an optical sensor installed on the Intercom board and will be activated when

the Intercom is removed from the case.

Each sensor can trigger up to five different actions:

• Flash the LED until the sensor is deactivated (roughly 10 times/second)

• Activate the relay until the sensor is deactivated

• Loop an audio file out of the Intercom speaker until the sensor is deactivated

• Call an extension and establish two way audio

• Call an extension and play a pre-recorded audio file

Note Calling a preset extension can be set up as a point-to-point call, but currently can't send

delayed DTMF tones.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 85 86

Pas de commentaire

CyberData 011272 Spécifications Page 43