CyberData 011214 Spécifications télécharger pdf (Page 19)

Installing the VoIP V3 Outdoor Intercom with Keypad

Intercom Setup

Operations Guide 930522C CyberData Corporation

2.3 Intercom Setup

2.3.1 Intercom Connections

Figure 2-3 shows the pin connections on the J3 (terminal block). This terminal block can accept

16 AWG gauge wire.

Note As an alternative to using PoE power, you can supply +12 to 24 VDC at 1000 mA (500 mA

minimum) into the terminal block.

Figure 2-3. Intercom Connections

Caution

Equipment Hazard: Contacts 1 and 2 on the J3 terminal block are only for

powering the Intercom from a non-PoE +12VDC power source as an alternative to

Network PoE power. Use of these contacts for any other purpose will damage the

Intercom and void the product warranty.

GENERAL ALERT

J3 Terminal Block

Wire (IN)

Terminal Block

can accept

16 AWG wire

Relay Contact:

(1A at 30 VDC for continuous loads)

3 = Normally Open Common

4 = Normally Open Contact

5 = Door Sense Input

6 = Door Sense Ground Reference

2 = Power Ground*

1 = +12 to 24 VDC at 1000 mA (500 mA minimum)*

Alternate Power Input:

*Contacts 1 and 2 on the J3 terminal block are only for

powering the Intercom from a non-PoE +12VDC power

source as an alternative to Network PoE power. Use of

these contacts for any other purpose will damage the

Intercom and void the product warranty.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 96 97

Pas de commentaire

CyberData 011214 Spécifications Page 19