CyberData 011171 Spécifications télécharger pdf (Page 10)

Implementing the VoIP V3 Zone Controller

Setting up the VoIP Zone Controller

Operations Guide 930446E CyberData Corporation

2.3 Setting up the VoIP Zone Controller

Before you set up the VoIP Zone Controller, be sure that you have received all the parts described in

Section 2.1, "Parts List".

2.3.1 Cables Used for Connecting to Legacy Analog Amplifiers

The VoIP Zone Controller connects to zones through RCA line level output connections to legacy

analog amplifiers to existing legacy analog speakers.

2.3.2 Connect to the Power Source

Figure 2-2. Connecting to the Power Source

Non PoE (with 48 VDC power supply)

Chassis Ground

PoE

To set up the VoIP Zone Controller, connect the

device to your network:

Poe

•For PoE, plug one end of an 802.3af Ethernet

cable into the VoIP Zone Controller Ethernet

port. Plug the other end of the Ethernet cable

into your network. See the figure on the left.

Non-Poe

•For Non-PoE, connect the VoIP Zone

Controller to a 48VDC power supply. See the

figure on the left.

Chassis Ground

• If required, connect the earth grounding wire

to the Chassis Ground on the back of the unit.

See the figure on the left.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 58 59

Pas de commentaire

CyberData 011171 Spécifications Page 10