CyberData SiP Compliant 010846 Spécifications télécharger pdf (Page 24)

Operations Guide 930098F CyberData Corporation

2.4.5 Broadcast a Test Message to a Specific Paging Zone

Once the VoIP Paging Gateway is set up and configured, you can broadcast test messages to

different paging zones that you specify. On the Home page, click Gateway Setup to open the

Gateway Configuration page.

You can broadcast a test message to all paging zones by using the Test/Reset switch on the back

of the VoIP Paging Gateway. See

Section 2.3.5, "Broadcast a test message to all paging zones" for

instructions.

Figure 2-10. Gateway Configuration Page

To broadcast a test message to a specific paging zone, complete the following steps:

1. Enter the paging Zone you want to test.

2. Click Audio Test. The VoIP Paging Gateway sends a brief audio message to that zone. Notice

that the round, green Paging light below the Status light blinks when a page is in progress

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 37 38

Pas de commentaire

CyberData SiP Compliant 010846 Spécifications Page 24