CyberData 011061 Spécifications télécharger pdf (Page 14)

Installing the VoIP V2 Paging Amplifier

Paging Amplifier Setup

Operations Guide 930324E CyberData Corporation

2.2.1 Paging Amplifier Components

Figure 2-3 shows the components of the Paging Amplifier .

Figure 2-3. Paging Amplifier Components

DIP Switches

Speaker Volume

Network Link LED (GREEN/YELLOW)

Status LED (GREEN)

A steady LED confirms that the Paging Amplifier is operational.

The LED will blink during a page when it is online.

Network Activity LED (GREEN)

Power LED (GREEN/BLUE)

The power LED is a steady green in low power mode and

a steady blue during high power mode. The power LED

will only blink either during a boot up or a phone call.

RTFM Switch

To broadcast a Paging Amplifier’s current IP address,

press and hold the RTFM switch for a couple of seconds

and then release it.

To restore the factory defaults, complete the following

steps:

1. Press and hold the RTFM switch until you hear the

Paging Amplifier announce the words, “restoring defaults”

and “rebooting”.

2. Release the RTFM switch. The Paging Amplifier will be

restored to the factory default settings.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 69 70

Pas de commentaire

CyberData 011061 Spécifications Page 14